PTFE-Lined Blind Flange Receiving Inspection and Ordering Checklist
Why inspect a lined blind flange differently?
A blind flange closes a piping opening, while the liner separates the process side from the metal body where the design provides coverage. Damage to the lining or its sealing surface can expose the underlying metal or prevent the mating surfaces from seating as intended. Inspecting the metal flange alone does not establish the condition of the lining. Acceptance should use the approved drawing, purchase specification and the supplier’s instructions for the actual product.
Receiving inspection checklist
| Check | What to compare or record | When to hold |
|---|---|---|
| Identity | Size, pressure class, facing, body material, lining designation, quantity and traceability against the purchase order. | Markings or documents do not match the order. |
| Dimensions | Flange outside diameter, thickness, bolt pattern and relevant mating dimensions against the approved standard or drawing. | A dimension cannot be verified or falls outside agreed acceptance criteria. |
| Lining and face | Inspect accessible surfaces for cuts, gouges, cracks, deformation, contamination and other damage; document location and photographs. | Damage or a questionable area is found; obtain the approved disposition. |
| Protection | Check covers, packing and identification, then protect the sealing surface until installation. | A missing cover or impact indicates possible transit damage. |
| Documents | Match required material, dimensional and examination records to the item and purchase order. | Required records or traceability are missing. |
Visual inspection has limits. It does not prove lining continuity, bond quality or service suitability. Any additional examination and acceptance criteria should be agreed before ordering.
Define the service before ordering
Give the supplier the process fluid and concentration, operating and design temperatures and pressures, any vacuum or pressure cycling, and cleaning or upset conditions. Compatibility depends on both the fluid and the actual construction. The metal flange pressure class alone does not establish the temperature or vacuum limit of a lined assembly; request the applicable product-specific limits and engineering review.
Agree the lining and examination scope
Identify the surfaces to be lined, the sealing-face arrangement and the drawing revision. If a project requires lining thickness measurements, continuity testing or other examination, specify the method, coverage, acceptance criteria and records in the purchase order. Do not assume that a test was performed or that a particular result is included unless the order documents confirm it.
Protect the face through installation
Keep protective covers in place until the item is ready for inspection and installation. Before assembly, confirm that mating faces are clean, aligned and compatible. Gasket choice, bolt loading and tightening sequence depend on the joint and the lining manufacturer’s instructions. Avoid applying a generic torque value to a different flange or lining construction. Follow the site’s isolation and safety procedures before opening an existing line.
ASME PCC-1 describes guidance for certain pressure-boundary bolted flange joints; its scope and the specific lined-product instructions must both be checked for the joint in question.
What should an enquiry include?
- Quantity, NPS or DN, flange standard and pressure class.
- Body material, lining material and required lined surfaces.
- Fluid, concentration, design temperature and pressure, vacuum and cycling conditions.
- Mating flange and sealing arrangement, plus an approved drawing where applicable.
- Inspection methods, acceptance criteria, traceability and required documents.
Related technical reading
Guide to flange face finishes explains metal flange surface terminology. Why flange gaskets should not normally be reused discusses joint-opening considerations; follow the specific lined-joint manufacturer’s instructions for gasket selection.
Technical references
ASME PCC-1, Pressure Boundary Bolted Flange Joint Assembly, scope and edition specified by the project; CRP, Introduction to Lined Piping, for general lining and installation considerations. These references do not certify the product or establish this site’s supply capability.
